Why is there foam overflowing from the detergent drawer of my Beko Washer?
If foam is overflowing from the detergent drawer of your Beko Washer, it's likely because too much detergent is being used. Mix 1 tablespoonful of softener with ½ liter of water and pour into the main wash compartment of the detergent drawer.
What to do if the Beko WMY 914831 program does not start after closing the door?
If the Beko Washer program doesn't start after closing the door, it could be because the Start / Pause / Cancel button was not pressed. Press the Start / Pause / Cancel button. Also, if you loaded too much laundry it may be difficult to close the loading door. Reduce the amount of laundry and make sure that the loading door is closed properly.
What to do if the Beko Washer loading door cannot be opened?
If the loading door of your Beko Washer cannot be opened, it could be due to several reasons: * The door lock is activated because of the water level in the machine. Drain the water by running the Pump or Spin programme. * The machine is heating up the water or it is at the spinning cycle. Wait until the programme completes. * The child lock is engaged. Wait a couple of minutes for deactivation of the door lock after the programme has come to an end. * The loading door may be stuck because of the pressure it is subjected to. Grab the handle and push and pull the loading door to release and open it.
Why is there water leaking from the bottom of my Beko Washer?
If you notice water leaking from the bottom of your Beko Washer, it could be that the water drain hose is clogged or twisted; clean or flatten the hose. It could also be that the pump filter is clogged; in this case, clean the pump filter.
What to do if my Beko WMY 914831 does not fill with water?
If your Beko Washer isn't filling with water, check the following: * Ensure the tap is turned on. * Make sure the water inlet hose isn't bent; flatten it if it is. * Clean the water inlet filter if it's clogged. * Ensure the loading door is closed properly.
Why is the washing performance of my Beko WMY 914831 Washer poor and clothes smell unpleasantly?
Poor washing performance and unpleasant smelling clothes in your Beko Washer may result from: * Odours and bacteria formed on the drum due to continuous washing at lower temperatures and/or in short programmes. Leave the detergent drawer and loading door ajar after each washing. * Excessive laundry load; do not overload the machine. * Damp detergent; keep detergents closed in a humidity-free environment and avoid excessive temperatures.
Why does my Beko WMY 914831 Washer programme time does not countdown? (On models with display)
If the programme time doesn't countdown on your Beko Washer (models with display), it could be because: * The timer may stop during water intake until the machine takes in adequate water. * The timer may stop during the heating step until the machine reaches the selected temperature. * The timer may stop during the spinning step due to unbalanced load distribution.
Why is my Beko Washer laundry does not smell like the softener?
If your laundry doesn't smell like the softener after washing in your Beko Washer, it could be because: * Detergent is put in the wrong compartment; put detergent in the correct compartment. * Detergent might be mixed with the softener; do not mix the softener with detergent. Wash and clean the dispenser with hot water.
Why does my Beko WMY 914831 Washer take longer time than specified in the manual?
Several factors can cause your Beko Washer to take longer than expected: * Low water pressure: The machine waits for adequate water intake, extending wash time. * Low voltage: Washing time is prolonged to avoid poor results. * Low water input temperature: Heating water takes longer in cold seasons. * Increased rinsing: The machine increases rinse water or adds an extra rinse if needed. * Excessive foam: Too much detergent can activate the foam absorption system, lengthening the cycle. Use the recommended amount of detergent.
Why does my Beko WMY 914831 Washer machine does not switch to spinning step?
If your Beko Washer doesn't switch to the spinning step, it could be due to: * Unbalanced load in the machine; the automatic unbalanced load detection system might be activated. * Water not drained completely; check the filter and the draining hose. * Excessive foam; use the recommended amount of detergent.
To Next Page
General