Beko WTB741R2W - Cancelling the Programme; End of Programme; Your Machine Features Standby Mode

33 / EN
Washng Machne / User’s Manual
4.6.16 Cancellng the programme
To cancel the programme, turn the Programme Selection knob to select another
programme. Previous programme will be cancelled. End / Cancel light will flash
continuously to notify that the programme has been canceled.
Your machine will end the programme when you turn the Programme Selection knob;
however, it does not drain the water inside. When you select and start a new programme,
the newly selected programme will start depending on the step the previous programme
was canceled in. For example, it may take in additional water or continue to wash with the
water inside.
C
Depending on the step where the programme was canceled in, you may have to put
detergent and softener again for the programme you have selected anew.
4.6.17 End of programme
“End” appears on the display at the end of the programme.
1. Wait until the loading door light illuminates steadily.
2. Press On / Off button to switch off the machine.
3. Take out your laundry and close the loading door. Your machine is ready for the next
washing cycle.
4.6.18 Your machne features "Standby Mode".
After you switch on your machine with On-Off button, if no programme is started or no
other procedure is performed at the selection step or no action is taken within approx. 2
minutes after the selected programme ends, your machine will switch to energy saving
mode automatically. The brightness of the indicator lights will decrease. Also, if your
product has a display that shows programme time, this display will be completely turned
off. If you turn the Programme Selection knob or touch any button, lights and display will
switch back to previous condition. The selections which you make when exiting from the
energy efficiency may change. Please check the correctness of your selections before
starting the programme. If necessary, please make your settings again. This is not an error.