What to do if my Beko WTC 8733 XB0B Washer won't drain water?
If your Beko Washer isn't draining water, the drain hose might be clogged or twisted, so clean or flatten it. Alternatively, the pump filter could be clogged, requiring cleaning.
How to open the loading door of my Beko WTC 8733 XB0B Washer?
If the loading door of your Beko Washer won't open, it could be due to a few reasons. The door lock might be activated because of the water level; drain the water by running the Pump or Spin program. The machine might be heating water or in the spinning cycle, so wait until the program completes. Alternatively, the child lock might be engaged; wait a couple of minutes after the program ends for it to deactivate.
Why does my Beko WTC 8733 XB0B not fill with water?
If your Beko Washer isn't filling with water, check if the tap is turned on and turn it on if it's off. Ensure the water inlet hose isn't bent, and flatten it if it is. Clean the water inlet filter if it's clogged. Also, make sure the loading door is closed properly.
What to do if my Beko WTC 8733 XB0B Washer doesn't rinse well?
If your Beko Washer isn't rinsing well, the detergent's amount, brand, or storage conditions might be inappropriate. Use a detergent suitable for washing machines and your laundry, and store detergents properly. Ensure the detergent is placed in the correct compartment. Also, check the pump filter and drain hose for any blockages.
Why is my Beko Washer taking longer than usual?
Several factors could cause your Beko Washer to take longer. The water pressure might be low, causing the machine to wait for an adequate amount of water. Low voltage or the input water temperature being low can also extend washing time. Additionally, the machine may increase the amount of rinse water or add an extra rinsing step, or excessive foam might have occurred due to too much detergent usage.
What to do if my Beko WTC 8733 XB0B is vibrating excessively?
Excessive vibration in your Beko Washer can stem from several issues. Ensure the machine is level by adjusting the feet. A hard substance might be in the pump filter, so clean it. Remove the transportation safety bolts if you haven't already. The laundry quantity might be too little or too much, so adjust the load accordingly. Also, ensure the machine isn't leaning on anything.
Why Beko Washer laundry doesn't smell like softener?
If your laundry doesn't smell like softener after washing in your Beko Washer, it could be because the detergent is put in the prewash compartment when a prewash cycle isn't selected. This can cause the machine to take the detergent during rinsing or the softener step. Also, detergent might be mixed with the softener. Do not mix the softener with detergent. Wash and clean the dispenser with hot water. Put the detergent in the correct compartment.
Why my Beko WTC 8733 XB0B Washer directly discharges the water it takes in?
The draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
To Next Page
General
