What to do if my Beko WTV 6633 BO Washer does not drain water?
If your Beko Washer isn't draining water, it could be due to a clogged or twisted drain hose. Try cleaning or flattening the hose. Alternatively, the pump filter might be clogged, so you should clean the pump filter.
How to open the loading door of my Beko WTV 6633 BO Washer?
If you can't open the loading door of your Beko Washer, it could be due to several reasons: 1. The door lock may be activated because of the water level. Drain the water by running the Pump or Spin program. 2. The machine may be heating water or spinning. Wait until the program is complete. 3. The child lock may be engaged. Wait a couple of minutes after the program ends for the door lock to deactivate. 4. The door may be stuck due to pressure. Try pushing and pulling the door to release it.
Why is my Beko WTV 6633 BO Washer leaking water from the bottom?
If water is leaking from the bottom of your Beko Washer, it might be because the water drain hose is clogged or twisted. Clean or flatten the hose. Another possibility is a clogged pump filter, which should also be cleaned.
What to do if my Beko WTV 6633 BO is not filling with water?
If your Beko Washer isn't filling with water, check the following: * Ensure the tap is turned on. * Make sure the water inlet hose isn't bent; flatten it if it is. * Check if the water inlet filter is clogged and clean it. * Ensure the loading door is closed properly.
Why does my Beko WTV 6633 BO discharge water immediately?
If your Beko Washer immediately discharges the water it takes in, the draining hose might not be at the correct height. Connect the water draining hose as described in the operation manual.
What to do if the programme cannot be started or selected on my Beko WTV 6633 BO Washer?
If a program cannot be started or selected on your Beko Washer, it might have entered self-protection mode due to a supply problem (line voltage, water pressure, etc.). To resolve this, press and hold the On / Off button for 3 seconds.
Why is my Beko Washer vibrating or making noise?
There are several reasons why your Beko Washer might be vibrating or making noise: * The machine may be unbalanced. Adjust the feet to level it. * A hard substance may be in the pump filter. Clean the pump filter. * The transportation safety bolts may not be removed. Remove these bolts. * The laundry quantity may be too little. Add more laundry. * The machine may be overloaded. Remove some laundry or distribute the load evenly. * The machine may be leaning on something. Ensure it's not leaning on any rigid item.
Why does washing take longer than specified in the manual on my Beko WTV 6633 BO?
Several factors can cause your Beko Washer to take longer than expected: * Low water pressure: The machine waits for adequate water, extending wash time. * Low voltage: Washing time is prolonged to ensure proper cleaning. * Low input water temperature: Heating the water takes longer. * Increased rinses: The machine may add extra rinse water or an additional rinsing step. * Excessive foam: The automatic foam absorption system may be activated due to too much detergent. Use the recommended amount of detergent.
What to do if my Beko WTV 6633 BO stopped shortly after the programme started?
If your Beko Washer stopped shortly after the program started, it may have temporarily stopped due to low voltage. It will resume running when the voltage returns to normal.
To Next Page
General
