Beko WTV 7516 BW User Manual (English)

Questions and Answers:

D
Dawn SchroederAug 22, 2025
What to do if the loading door of my Beko WTV 7516 BW won't open?
- V
  vanessaedwardsAug 22, 2025
  If the loading door of your Beko Washer won't open, it could be due to several reasons. The door lock may be activated because of the water level, so drain the water by running the Pump or Spin programme. The machine might be heating up the water or is at the spinning cycle, so wait until the programme completes. If the child lock is engaged, wait a couple of minutes for deactivation of the door lock. The loading door may be stuck because of pressure, so grab the handle and push and pull the loading door to release and open it.
M
Mrs. Stephanie DonaldsonAug 23, 2025
How to fix a Beko WTV 7516 BW that does not drain water?
- J
  Jennifer ChapmanAug 23, 2025
  If your Beko Washer isn't draining water, the water drain hose might be clogged or twisted, so clean or flatten the hose. Alternatively, the pump filter could be clogged, so clean the pump filter.
K
Katie FitzgeraldAug 25, 2025
Why won't my Beko WTV 7516 BW Washer switch to the spinning step?
- C
  Christopher DanielsAug 26, 2025
  If your Beko Washer isn't switching to the spinning step, there might be an unbalanced load in the machine, which activates the automatic unbalanced load detection system due to the laundry's uneven distribution in the drum. Also, the machine won't spin if the water isn't drained completely, so check the filter and the draining hose. Excessive foam might have occurred, activating the automatic foam absorption system due to too much detergent, so use the recommended amount of detergent.
R
Ricky WebbAug 27, 2025
What to do if my Beko WTV 7516 BW enters standby mode or doesn't take in water?
- C
  crosbyandrewAug 27, 2025
  If your Beko Washer enters standby mode or doesn't take in water, check if the tap is turned on and turn it on if it's off. Also, ensure the water inlet hose isn't bent; if it is, flatten it. The water inlet filter might be clogged, so clean the filter. Ensure the loading door is closed properly. Check the water connection and if the water is cut off, press the Start/Pause key after the water has been supplied again to resume the operation from standby mode.
M
Michael AndrewsAug 28, 2025
How to start a Beko WTV 7516 BW Washer if the program doesn't start after closing the door?
- R
  Robert YoungAug 28, 2025
  If the program on your Beko Washer doesn't start after closing the door, ensure you've pressed the Start / Pause / Cancel button. Also, it may be difficult to close the loading door in case of excessive loading, so reduce the amount of laundry and make sure that the loading door is closed properly.
J
John CampbellAug 29, 2025
Why doesn't my Beko WTV 7516 BW rinse well?
- J
  Justin LewisAug 29, 2025
  If your Beko Washer doesn't rinse well, the amount, brand, and storage conditions of the detergent might be inappropriate, so use a detergent suitable for washing machines and laundry, and store it properly. Also, ensure the detergent is put in the correct compartment. A clogged pump filter can also cause this, so check the filter. Finally, check the drain hose for any folds.
M
mcphersontheresaAug 30, 2025
What to do if a programme cannot be started or selected on my Beko Washer?
- J
  julie07Aug 31, 2025
  If a programme cannot be started or selected on your Beko Washer, the washing machine has likely switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). To cancel the programme, turn the Programme Selection knob to select another programme. The previous programme will be canceled.
S
Steven DouglasSep 1, 2025
Why is there detergent residue in the detergent drawer of my Beko Washer?
- J
  Justin MurraySep 1, 2025
  If you notice detergent residue in the detergent drawer of your Beko Washer, it could be because the detergent drawer was wet when you put in the detergent, so dry the detergent drawer before adding detergent. The detergent might have gotten damp, so keep detergents closed in a humidity-free environment and avoid excessive temperatures. Low water pressure could be a factor, so check the water pressure. The detergent in the main wash compartment might have gotten wet while taking in the prewash water, so check the holes and clean them if they're clogged. Also, make sure you're not mixing the softener with detergent, and wash and clean the dispenser with hot water.
M
meyersbobbySep 2, 2025
Why doesn't my laundry smell like softener after using my Beko Washer?
- A
  Alexandra AlvaradoSep 3, 2025
  If your laundry doesn't smell like softener after using your Beko Washer, ensure the detergent is put in the correct compartment. If detergent is put in the prewash compartment although prewash cycle is not selected, machine can take this detergent during rinsing or softener step. Wash and clean the dispenser with hot water. Also, do not mix the softener with detergent and wash and clean the dispenser with hot water.
K
Kimberly HarrellSep 4, 2025
Why is my Beko Washer vibrating and making noise?
- E
  Elizabeth BatesSep 4, 2025
  Your Beko Washer might be vibrating or making noise due to several reasons. The machine might be standing unbalanced, so adjust the feet to level it. A hard substance might have entered the pump filter, so clean the pump filter. Ensure the transportation safety bolts are removed. The laundry quantity might be too little, so add more laundry. If overloaded, take some laundry out or distribute the load evenly. Also, ensure the machine isn't leaning on anything.

Beko WTV 7516 BW Specifications

General

Capacity	7 kg
Spin Speed	1200 rpm
Energy Efficiency Class	A+++
Dimensions (H x W x D)	84 cm x 60 cm x 49 cm
Weight	70 kg
Maximum Spin Speed	1200 rpm
Noise Level (Washing)	56 dB
Water Consumption per Year	9900 L
Programs	15
Color	White
Type	Front Load Washing Machine