Why my Beko WUX71031W-IT stopped shortly after the programme started?
If your Beko Washer stopped shortly after the program started, it might have stopped temporarily due to low voltage. It will resume running when the voltage restores to the normal level.
How to open the loading door of my Beko WUX71031W-IT?
If the loading door of your Beko Washer won't open, it could be due to several reasons. The door lock might be activated because of the water level in the machine; drain the water by running the Pump or Spin program. The machine may be heating up the water or is at the spinning cycle; wait until the program completes. The child lock may be engaged; wait a couple of minutes for deactivation of the door lock. The loading door may be stuck because of the pressure it is subjected to; grab the handle and push and pull the loading door to release and open it.
Why my Beko WUX71031W-IT Washer does not fill with water?
If your Beko Washer isn't filling with water, check if the tap is turned on. Also, inspect the water inlet hose to ensure it isn't bent; flatten it if it is. The water inlet filter might be clogged, so clean it. Finally, make sure the loading door is closed properly.
What to do if there is water leaking from the bottom of my Beko Washer?
If you notice water leaking from the bottom of your Beko Washer, it could be due to a clogged or twisted water drain hose; clean or flatten the hose. Another possibility is a clogged pump filter, which you should also clean.
Why my Beko WUX71031W-IT Washer does not switch to spinning step?
If your Beko Washer doesn't switch to the spinning step, there might be an unbalanced load in the machine. Also, the machine will not spin if water is not drained completely, so check the filter and the draining hose. Excessive foam might have occurred due to too much detergent usage; use the recommended amount of detergent.
Why is foam overflowing from the detergent drawer of my Beko WUX71031W-IT Washer?
If foam is overflowing from the detergent drawer of your Beko Washer, it is possible that too much detergent is used. Mix 1 tablespoonful softener and ½ l water and pour into the main wash compartment of the detergent drawer. Put detergent into the machine suitable for the programmes and maximum loads indicated in the “Programme and consumption table”. When you use additional chemicals (stain removers, bleachs and etc), reduce the amount of detergent.
Why is the washing performance poor and clothes smell unpleasantly in my Beko Washer?
If your clothes smell unpleasantly after washing in your Beko Washer, odours and bacteria layers might have formed on the drum due to continuous washing at lower temperatures and/or in short programmes; leave the detergent drawer and the loading door ajar after each washing. Avoid loading the machine in excess. Ensure the detergent in use is not damp; keep detergents closed in a humidity-free environment and do not expose them to excessive temperatures.
Why laundry does not smell like the softener after washing in my Beko WUX71031W-IT Washer?
If your laundry doesn't smell like the softener after washing in your Beko Washer, it could be because detergent is put in the wrong compartment; if detergent is put in the prewash compartment although prewash cycle is not selected, machine can take this detergent during rinsing or softener step. Wash and clean the dispenser with hot water. Put the detergent in the correct compartment. Also, avoid mixing the softener with detergent, and wash and clean the dispenser with hot water.
Why programme time does not countdown on my Beko WUX71031W-IT Washer? (On models with display)
If the programme time isn't counting down on your Beko Washer, the timer may stop during water intake until the machine takes in enough water. The timer may also stop during the heating step until the machine reaches the selected temperature. Also, the timer may stop during the spinning step if the automatic unbalanced load detection system is activated.
Why is my Beko Washer vibrating or making noise?
There are several reasons why your Beko Washer might be vibrating or making noise. It could be due to the machine standing unbalanced, so try adjusting the feet to level it. A hard substance might have entered the pump filter, so you may need to clean the pump filter. Ensure the transportation safety bolts are removed. The laundry quantity in the machine might be too little or too much; add more laundry or take some out. Also, make sure that the machine is not leaning on anything.
Safety instructions for preventing injuries and material damage risks.
Guidelines for safe use by children and supervision requirements.
Precautions regarding electrical connections, grounding, and water contact.
Warning about hot surfaces, especially the door glass, during operation.
Information on proper disposal of electrical waste according to WEEE directive.
Confirmation of compliance with RoHS Directive regarding hazardous materials.
Details about the recyclability of packaging materials.
Guidance on selecting a suitable and stable location for the washing machine.
Instructions for removing shipping bolts to prevent damage during operation.
Steps and precautions for connecting the water inlet hose.
Instructions for correctly attaching the drain hose to a waste outlet.
How to level the machine using adjustable feet for stability and reduced noise.
Requirements for connecting the machine to a grounded electrical outlet.
Steps to take before the first wash cycle, including drum cleaning.
Guidelines for separating laundry by fabric type, color, and soiling level.
Instructions for preparing clothes, such as checking pockets and removing attachments.
Recommendations for efficient washing to reduce resource consumption.
Steps for properly loading clothes into the washing machine drum.
Advice on not overloading the machine for optimal performance.
Guidance on selecting and using detergents and fabric softeners correctly.
Instructions for using liquid detergents with different dispenser types.
How to add gel or tablet detergents to the machine.
Instructions for using starch and cleaning after use.
Guidance on using specific products for limescale removal.
Precautions and methods for using bleaching agents.
Recommendations for heavily soiled clothes based on color.
Recommendations for normally soiled clothes based on color.
Recommendations for lightly soiled clothes based on color.
Explanation of various program and function symbols used in the manual.
Overview of the washing machine's control panel and its buttons/dials.
Steps to perform before starting a wash cycle.
Guidance on choosing the right program and saving resources.
Detailed description of the Cotone program for cotton laundry.
Details on the Synthetics program for synthetic fabrics and curtains.
Information on the Woollens/Hand Wash program for delicate items.
Description of the Eco 40-60 program and its energy/water efficiency.
Details on the Cottons 60/Classic program for durable cottons.
Information on the Cottons 60 with Prewash program for heavily soiled items.
Program for quick washing of lightly soiled cotton clothes.
Program designed to wash shirts, reducing wrinkles.
Program for washing feathered items like coats and jackets.
Maintenance program for cleaning the washing drum.
Adjusting the spin speed for different wash cycles.
Function to hold laundry in rinse water to prevent wrinkles.
Setting a delayed start time for washing programs.
How to modify the delay time once set.
Procedure to cancel the delayed start function and start immediately.
How to initiate a selected washing program.
Features and operation of the child lock.
Steps to enable the child lock feature to prevent program changes.
Steps to disable the child lock feature.
Monitoring the stages of a running washing program.
Explanation of the door lock's function and indicators.
Modifying program settings while the machine is running.
How to temporarily stop the machine during a cycle.
Adjusting spin speed while a program is active.
Procedure to add or remove items during a paused cycle.
Steps to abort a running washing program.
Indicators and steps upon completion of a wash cycle.
Automatic energy saving features and display behavior.
Instructions for cleaning the detergent dispenser and siphon.
Guide to cleaning the door seal and the washing drum.
How to clean the exterior of the machine and its controls.
Steps for cleaning the filters that prevent debris from entering the machine.
Procedure to drain water and clean the pump filter.
Solutions for when the program fails to start after the door is closed.
Troubleshooting steps for issues with starting or selecting programs.
Explanation of residual water and if it's a fault.
Solutions for when the machine does not draw water.
Troubleshooting for problems with water drainage.
Causes and solutions for excessive vibration or noise.
Identifying and fixing leaks from the machine's base.
Reasons and solutions for unexpected program interruption.
Troubleshooting for immediate water discharge.
Explanation for not seeing water during the wash cycle.
Solutions for when the loading door remains locked.
Reasons for extended washing times.
Troubleshooting for countdown timer issues on display models.
Solutions for when the machine skips the spin cycle.
Addressing laundry turning gray due to washing issues.
Solutions for incomplete stain removal or lack of whitening.
Addressing oily stains on laundry.
Solutions for unpleasant odors on laundry.
Reasons and solutions for color fading in laundry.
Troubleshooting for inadequate rinsing performance.
Solutions for laundry feeling stiff after washing.
Addressing issues where laundry doesn't smell of softener.
Causes and solutions for detergent residue in the drawer.
Troubleshooting excessive foam formation in the machine.
Solutions for foam overflowing the detergent drawer.
Addressing laundry remaining wet after the cycle.
General| Door hinge | Right |
|---|---|
| Motor type | Digital inverter |
| Water fill | Cold, Hot |
| Control type | Buttons, Rotary |
| Display type | LED |
| Loading type | Front-load |
| Product color | White |
| Built-in display | Yes |
| Custom panel-ready | No |
| Appliance placement | Freestanding |
| Drum capacity | 7 kg |
| Cycle time (max) | 220 min |
| AquaStop function | - |
| Delay start (max) | 9 h |
| Residual moisture | 62 % |
| Spin-drying class | C |
| Maximum spin speed | 1000 RPM |
| Noise level (spin) | 72 dB |
| Noise level (wash) | 62 dB |
| Number of washing programs | 15 |
| Cycle time (quick washing program) | 28 min |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Energy efficiency scale | A to G |
| Power consumption (off) | 0.5 W |
| Power consumption (left-on) | 1 W |
| Energy consumption washing per cycle | 0.91 kWh |
| Package depth | 515 mm |
| Package width | 650 mm |
| Package height | 880 mm |
| Package weight | 62000 g |
Weight and Dimensions| Depth | 490 mm |
|---|---|
| Width | 600 mm |
| Height | 840 mm |
| Weight | 61000 g |
To Next Page
