GLISS
RECORD
Selector 2: Playback
Loop
PATCHING TIP
Set the input to Dual Slider and playback to Trigger, to
have 2 envelope generators with custom shapes. You can draw
in your envelope shapes on the 2 halves of the Touch Strip
and then trigger them simultaneously with the Button or a
trigger input. This is great for situations in which you
want to simultaneously control a VCA as well as a VCF cutoff
frequency for some acid bass lines.
A trigger signal is a signal that
goes from minimum to maximum
voltage, like a momentary switch.
A GATE signal, however, is a voltage
that goes from minimum voltage to
maximum voltage, and stays there
until it is turned off. Common ways
of creating GATE signals are
keyboards, sequencers, and LFOs.
To Next Page
Loading...