bela GLISS - About this Manual

GLISS 





bela.io/upgrade-gliss
Note 1: When you ash your module to a new version, all your seings (such as custom
voltage ranges) are erased, so you’ll have to set them again.
Note 2: After ashing the module and reconnecting it to your system you’ll have to run
the one-minute calibration process. Your Gliss should enter Calibration Mode
automatically when you reconnect it after ashing, but you can also enter Calibration
Mode by holding down the Mode Selector from any mode Menu.
About this manual





About this version


Get support







And nally ...


