Hood (BELARUS-1221.3)
The mask and hood are hinged on supports located on the front of the frame immediately
behind the heat exchanger block of engine cooling. The fastening of the mask and hood is
designed to allow quickly opening them and thus having a quick access to separate units of
the tractor.
To remove the left side panel (4), open two locks (7) on the left side and remove the
side panels (4).
To remove the right side panel (5), open the two locks (7) on the right side and remove the
side panel (5).
To open the hood 3 and lock it open, proceed as follows:
- close the mask (2) if it was in the open position;
- remove the monocyclone (1);
- open the lock (15) by pulling the cable (9);
- grip the edge of the hood (3) (near the cab) and open it to its highest position;
- fix the hood (3) with the rod (12) in the bracket (13).
To open the mask (2) and lock it in raised position, proceed as follows:
- close the hood 3 if was open;
- open the lock (8) by pulling the cable (6);
- grip the bottom edge of the mask (2) and open it to its highest position;
- fix the mask (3) with the rod (11) in the bracket (10).
Do not open the hood (3) and mask (2) simultaneously.
ATTENTION: before you start maintenance works in the area under the mask and hood,
make sure they are securely locked open!
To Next Page