Unmount-mount facing sides
1 – monocyclone; 2 – mask; 3 – hood; 4 – left side; 5 – right side; 6 – cable; 7 – lock; 8 – lock;
9 – cable; 10 – bracket; 11 – arm; 12 – arm; 13 – bracket; 14 – latch; 15 – lock.
To install the sides (4) and (5), proceed as follows:
- install the latches (14) of the sides to the seats on the brackets (16);
- fasten the sides (4), (5) with the locks (7).
To lower and close the hood (3), proceed as follows:
- slightly raise the hood (3) to release the rod (12);
- secure the rod (12) in the clamp on the hood (3);
- lower the hood (3) to its low position until a distinctive click is heard (the lock (15)
engages);
- install the monocyclone (1);
To lower and close the mask (2), proceed as follows:
- slightly raise the mask (2) to release the rod (11);
- secure the rod (11) in the clamp on the mask;
- lower the mask (3) to its low position until a distinctive click is heard (the lock (8)
engages);
To Next Page