“Reverse position” (for the trac-
tor with the reverse control panel
“BELARUS-1221В.2”). To set the seat
to the reverse position it is necessary to
turn the clamps “Г” off and move them
out of the panel brackets edges “Д”, lift
the lever “Е” and turn the seat half-way
(180°). Sharply lift and pull it the seat
upwards. Set the screws “Ж” into the
slots of the panel brackets “Д”, put the
screw «З» on in the brackets to the stop
and fasten the clamps “И” with the turn-
ing torque 44 … 56 Nm.
To Next Page