F5D8236-4_V1000_N_RTR_MNL-CLEAN.doc
Page 56 of 111
Setting WPA-PSK
1. From the “Security Mode” drop-down menu, select “WPA/WPA-Personal
(PSK)”.
2. For “Encryption Technique”, select “TKIP” or “AES”. This setting will have to
be identical on the clients that you set up.
3. Enter your pre-shared key. This can be from eight to 63 characters and can
be letters, numbers, or symbols. This same key must be used on all of the
clients that you set up.
4. Click “Apply Changes” to finish. You must now set all clients to match these
settings.
[insert Security_WPA.tif]
Setting WEP Encryption
Note to Mac users: The “Passphrase” option will not operate with Apple
®
AirPort
®
. To configure encryption for your Mac computer, set the encryption using
the manual method described in the next section.
1. Select “128-bit WEP” or “64-bit WEP” from the drop-down menu.
2. After selecting your WEP encryption mode, you can enter you WEP key
manually by typing in the hex WEP key manually, or you can type a
passphrase in the “PassPhrase” field and click “Generate” to create a WEP
key from the passphrase. Click “Apply Changes” to finish. You must now set
all of your clients to match these settings.
To Next Page
