To Next PageTo Next PageWhat to do if the Link LED is solid but I cannot connect to the Internet using Belkin Play N600 DB Adapter?
If the Link LED is solid but you cannot connect to the Internet, it indicates a mismatch between the encryption key settings on your computer and wireless router (or access point). You should check the WEP, WPA, or WPA2 key settings to ensure they match.
Why is the signal strength poor on my Belkin Play N600 DB?
Poor signal strength on your Belkin Adapter can be due to increased distance between devices and obstructions like walls and metal appliances. Try temporarily moving the computer five to 10 feet away from the wireless router (or access point). Also, changing the wireless channel may improve performance and reliability, depending on local wireless traffic and interference.
What to do if Link LED is blinking slowly and I cannot connect to a wireless network or the Internet using Belkin Play N600 DB?
If the Link LED is blinking slowly and you cannot connect to a wireless network or the Internet, this is due to a mismatch between the network name (SSID) settings in your wireless network properties. Check the SSID settings to see if they match.
Why is data transfer sometimes slow with my Belkin Adapter?
Slow data transfer with your Belkin Adapter can occur when the distance between devices increases or when there are obstructions such as walls and metal appliances. Temporarily move the computer closer, about five to 10 feet away from the wireless router (or access point) to improve data transfer.
What to do if the Power LED does not come ON and Belkin Adapter is not working?
If the Power LED does not come on and the Adapter is not working, verify that the Adapter is plugged firmly into the USB port of your computer. Also, check that the drivers for the Adapter have been installed.
What to do if Belkin Play N600 DB doesn't perform or connection is unstable when computer has a second built-in wireless network card?
If the Belkin Adapter doesn't perform or the connection is unstable when your computer has a second built-in wireless network card, you must disable the built-in wireless card from your computer under “Network Adapters” in the Device Manager.
What to do if Belkin Play N600 DB doesn't perform or connection is slow when computer has a built-in wired Ethernet card?
If the Adapter does not perform or the connection is slow when your computer has a built-in wired Ethernet card, you must disable the Ethernet card from your computer under “Network Adapters” in the Device Manager.
General| Frequency Bands | 2.4 GHz and 5 GHz |
|---|---|
| Wireless Standards | 802.11n |
| Ports | 4 x Ethernet ports |
| Security | WPA/WPA2 |
| Antennas | Internal |
| Wireless Speed | Up to 300 Mbps per band (600 Mbps total) |
