To Next Page
R
raymond98Aug 9, 2025
What to do if Bell Log Splitter fails to split logs?
- Llatoya54Aug 10, 2025
If your Bell Log Splitter fails to split logs, it could be due to several reasons. First, the log might be too large; try cutting a smaller piece or reducing its size by other means. Second, the log may be incorrectly positioned; adjust its position in relation to the wedge. Another reason may be that the wedge is not sharp enough; sharpen the wedge and check for burrs or nicks, filing them if necessary. Also, check for an oil leak using a piece of card or wood and contact your dealer. Finally, the hydraulic pressure might be too low, in that case you should contact your dealer.
General
