Bell PICKPINE CELTIS 100 Series User Manual

SPACCALEGNA
LOG SPLITTER
HOLZSPALTER
FENDEUSE DE BOIS
s.r.l.
D22031470 - v.1 - UPD 191107 - © 2007 BELL
MANUALE DI USO E MANUTENZIONE
MANUAL FOR USE AND MAINTENANCE
WARTUNGS-UND BETRIEBSANLEITUNG
LIVRET D'EMPLOI ET D'ENTRETIEN

Bell PICKPINE CELTIS 100 Series Specifications

General

Model	PICKPINE CELTIS 100 Series
Category	Log Splitter
Power Source	Electric
Splitting Force	10 tons
Voltage	230V
Frequency	50Hz

Summary

Introduction

Description of the Machine

1.1 - Symbols used

Explains standard graphic symbols for machine safety and operation.

Technical Data

2.1 - Size of the logs to be split

Shows maximum log sizes and factors affecting splitting.

2.2 - Recommended oils

Lists recommended hydraulic oils for the cylinder.

Safety

3.1 - General safety regulations

Outlines general safety rules for operating the log splitter.

Operating the Machine for the First Time

4.1 - Assembly of the wheels (if the log splitter is unassembled when supplied)

Instructions for fitting the wheels to the log splitter.

4.2 - Assembly of the arms (if the log splitter is unassembled when supplied)

Steps for assembling the arms if the machine is delivered disassembled.

4.4 - Lighting

Discusses the importance of adequate lighting for safe operation.

Use

5.1.A - Switching on/off of the machine with electric motor

Guides on how to start and stop electric motor log splitters.

5.1.B - Switching on/off of the machine driven by cardan shaft

Instructions for operating log splitters powered by a cardan shaft.

5.1.C - Switching on/off of the log splitter with premium graded fuel engine

Details on starting and stopping log splitters with a fuel engine.

5.2 - How to use log splitter

Step-by-step guide on how to split logs safely and effectively.

5.3 - Movable table

Information on adjusting the movable table for different log sizes.

5.4 - How to adjust blade stroke

Explains how to set the wedge travel for short logs to save time.

5.5 - How to transport the log splitter

Instructions for safely moving the log splitter using its handle.

5.6 - Assembly and use of the 4-way wedge (optional)

Guidance on fitting and using the optional 4-way splitting wedge.

Routine Maintenance

6.1 - How to clean the oil filter

Steps for cleaning the hydraulic system's oil filter.

6.2 - How to change the hydraulic oil

Procedure for replacing the hydraulic oil after a specified period.

6.3 - Sharpening the wedge

Instructions on how to sharpen the splitting wedge.

Troubleshooting

7.1 - Resetting of the thermal cut-out of the electric motor

How to reset the electric motor's thermal protection device after overload.

Scrapping and Disposal of the Machine

Spare Parts

Guarantee