20
Bellfires
English
Instructions for use and installation instructions
3.2 BARBAS AND ONTOP CONCENTRIC FLUE Ø100 MM - Ø150 MM SYSTEM
The appliance is in combination with the concentric flue system [Ø100 mm – Ø150 mm]
(either rigid or flexible) of Barbas or Ontop (US system) compliant with the European
CE norm for gas appliances, and may therefore only be used with these systems.
The guarantee is invalidated if the appliance is (completely or partially) installed using a
different system.
The Barbas and Ontop concentric flue [Ø100 mm - Ø150 mm] systems can be used
with either a newly-built or existing chimney.
3.3 PREPARATION FOR INSTALLATION
The following preparation must be carried out before the gas fire can be installed.
3.3.1 Instructions for positioning the outlet
3.3.1.1 Positioning the outlet for correct operation:
Roof-mounted outlet:
Figure 6: Roof-mounted outlet
This must be positioned at least 0.5 m from the roof edge;
the apex of the roof can be disregarded.
Wall-mounted outlet:
Figure 7: Wall-mounted outlet
This must be positioned at least 0.5 m from:
• the corner of the building.
• the roof overhang, the rain gutter.
• balconies etc., unless the exhaust construction
extends to at least the face of the protruding section.
>0,5 m
>0,5 m
To Next Page
Loading...
