Instructions for Use
20
Maintenance and Cleaning
Automatic Defrosting of the Refrigerator
There is no need to defrost the refrigerator, because ice depositing on the inner
back wall is defrosted automatically.
Manual Defrosting of the Freezer
When the frost and ice layer in the freezer is 3-5 mm thick, you should clean
the freezer.
• Few hours before defrosting set the
thermostat to position 7, so that
packages are well frozen. Reset the
thermostat to STOP (0) position and
disconnect the power supply. Empty
the freezer and take care that the
packages remain frozen.
• Insert the enclosed pipe into the
groove in the bottom of the appliance and place a vessel
underneath to collect the defrost water. Defrosting is accelerated if
the door is left open.
• Avoid using defrosting sprays, as they may cause damage to the
plastic parts and may be hazardous to health.
Cleaning the Appliance
Disconnect the power supply before cleaning the appliance.
Do not use coarse or aggressive cleaning agents as you can damage
the surface.
• Clean the exterior with water and detergent.
The application of abrasive and specially aggressive cleaners, such
as stainless steel cleaners, is not appropriate for cleaning of plastic
and coated parts.
• Remove the detachable accessories in the interior of the appliance
and clean it with water and liquid
detergent. Plastic parts cannot be
washed in the dishwasher.
• Wash the interior of the appliance with
lukewarm water, in which you may add
one or two spoonfuls of vinegar.
• Every now and then wipe the
condenser on the rear wall. Use a soft
non-metal brush or vacuum cleaner.
To Next Page
Loading...
