Glen Dimplex NZ Ltd
38 Harris Road, East Tamaki, Auckland 2013
Ph: 274 8265
www.belling.co.nz
READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND USING
THE APPLIANCE.
The manufacturer will not be responsible for any damage to property or to
persons caused by incorrect installation or improper use of the appliance.
The manufacturer is not responsible for any inaccuracies, due to printing or
transcription errors, contained in this handout.
In addition, the appearance of the figures reported is also purely indicative.
The manufacturer reserves the right to make changes to its products when
considered necessary and useful, without affecting the essential safety and
operating characteristics.
Belling constantly seeks ways to improve the specifications and designs of
their products.
Whilst every effort is made to produce up to date literature, this document
should not be regarded as an infallible guide.
Actual product only should be used to derive cut out sizes.
All Belling Appliances must be installed by a qualified person/s with adherence
to the relevant electrical, plumbing and gas codes, with compliance being
issued as required by state or national legislation.
Additionally all Belling Upright cookers must have chains installed correctly in
adherence to the relevant gas and plumbing codes by the licensed installer.
For maximum effectiveness and efficiency all range hoods should be installed
with the use of ductwork, by a licensed installer with adherence to the relevant
state and national building codes and regulations.
All Belling appliances are for Domestic use only, and must be installed by a
licensed installer into Domestic Applications only, without exception and to the
required Authorities guidelines.
Any installation outside of this will VOID warranty. Alfresco areas are not a
Domestic application.
To Previous Page
Loading...
