EasyManua.ls Logo

Belling IDW450MK2 - Page 28

Belling IDW450MK2
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Fuse blown, or th e
circuit breaker acted
Replace fuse or reset circuit breaker. Remove any other
appliances sharing the same circuit with the dishwasher
Spilled rinse- aid
Always wip e up rinse- aid spills immediat ely.
Hard water minerals
The affe cted items are
not corrosion resistant.
The lid of the softer
is loose
Aspayarmis
knockin g against
an item in a basket
r
Items of cro c kery
are loose in the
wash cabinet
This may be caused
by on-site installation
or the cross-section of
the piping.
A programme was not
run after dishwasher
salt was added.
Tra ces of salt have
gotten into the wash cycle .
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves.
Never use any other cleaner than dishwasher
detergent for the risk of foaming or suds.
Always run the quick wash programme .
without any crocke ry in the dishwasher and
without selecting the T urbo function (if pres ent),
after adding dishwasher salt.
Check the lip .Ensure the fix is fi ne.
Interrupt the programme, and rearrange the items
which are obs tructing the sp ay arm.r
Interrupt the programme,
and rear range the items of croc kery .
This has no influence on the dishwasher function.
if in doubt, contact a suitably qualified plumber.
Detergent with
colo urant was used
Make sure that the detergent is the one without
colourant.
Improper detergent
Make sure the dishwasher is turned on and the door is
closed securely.
Check that the water supply is connected properly and
the water is turned on.
Make sure to close the door properly and latch it.
Make sure the power cord is properly plugged into the
wall socket.
Power supply is not
turned on
Error code:E1;
Water pressure is low
Door of dishwasher
not properly closed.
Kink in drain hose
Filter clogged
Kitchen sink clogged
Check drain hose.
Check coarse the filter
(see sectio n titled )" Cleaning The Filter "
Check the kitchen sink to make sure it is draining well.
If the problem is the kitc hen sink not draining ,you may
need a plumber rather than a serviceman for dishwashers.
Use only the special dishwasher d etergent to av oid
suds. If this occurs, open the dishwa sher and let suds
evaporate. Add 1 gallon of cold water to the tub. Close
and latch the dishwasher, then Start the "soak" wash
cycle to drain out the water . Repeat if necessary.

Related product manuals