Witheachwashcycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models with water softener system only .)
Elec tric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimat e when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Close the doo r, turn on the water tap. The machine will start working after about 10 seconds.
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the deter gent dispenser
Warning: wait a few minutes (about 15 minutes) before unloa ding the dishwasher to avoid handling
the dishes and utens ils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower b asket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then l oad the baskets. Refer to the dishwasher loading instructions.
Press the Programme button until the sele cted programme lights up.
( See the section entitled Operationg instruction )āā
When the working cycle has fini shed, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Open t he door careful ly.
Hot st eam may esc ape
when the door isopened!
If the applianc e is switched off during a wash cycle, wh en switched
on again, please re-select th e washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the On/Off button to switc h on the applian c e, Open the door.
1.Open the doo r a little to sto p th e dishwasher.
2.After the spra y arms stop work in g, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishw asher will start running again after 10 sec onds.
C
For detailed operating method read the corresponding content on the instructio n manual.
1. A running cycle can o nly be modified if it has been running for a short time. O therwise the detergent
m ay have already been released and the water already drained. If this is th e case, the detergent
dispenser must be refilled.
2. Open the door a little to s top the was h ing, then press the Program button for more than 3 seconds to
c ancel the running programme.
3. Select a new programme , then close the door. The machine will restart after about 10 seco nds .
To Next Page
Loading...