The cont rol p anel can be clea ned by using a l ightly dampen ed c loth.
Aft er cl eaning, m ake sure t o dry it tho roughly.
For the e xte rior, use a good app li ance polis h wax .
Never u se s harp object s, sco uri ng pads o rhar sh c lean ers on a ny part o f the di shwasher.
Protect Again st Freezing
1.Cutoff the electrical power to the dishwasher.
2.Turn off the wat er su ppl y an d d is connec t th e wat er i nlet pipe from the w ate r val ve.
3.Drain the water from the inlet pipe an dwater valve. (Use a pan to catch thewater)
4.Reconnect t he wate r i nl et pi pe to the wa ter valve.
5.Remove the f ilter at the bottom of the tub and use a spong e to soak up water in the sum p.
pl ease take fros t pr ot ection meas ures o n t he dishwasher in wint er. Ev ery fter wa shing c ycles,
pl ease operat e as f ollows
time a
：
- Inspec t t he filters for blo ckin ga fter e ver y tim e th e di shwasher ha s be en u sed.
- By uns crew ing the c oar se fi lter, you can remove the filter syst em . Re move an y foo d re mna nts and
cleanthefilters underrunningwater.
Remarks:
Cleaning the Filter
Cleaning The Door
To c lean th e c o a rse f ilt er and the fin e fi lte r, us e a cleani n g bru sh . Reas se mble t he f ilt er par ts as sho wn in t h e fi gures
on th e las t pa ge a nd r ein sert t he e nti re ass emb ly in the dis hwa sher, pos itio ning it i n i ts s eat and pres sing dow nwar ds.
The entire filter assembly should be cleaned once a week.
When cleaning the filters, don't knock on them. Otherwise, the filters could be
contorted and theperformance ofthe dishwasher couldbedecreased.
To cle an the e dge ar ound t he d oor, you s hould u se only a soft warm, d am p cl oth.
To avoi d pene trati ono f wa te r in to t he d oor lock and el ectrical com ponen ts, d o no t
use a spr ay cleaner of any ki nd.
Never u se a spr ay c leaner t o cle an t he d oor panel as it m ay dam age the door loc k
and electrical components.
Ab rasive ag ent sor some paper towels s hou ld not b e u sed becau se o f th er is ko f
scra t c hing o r l eav ing s pot s on the stai n less steel s urfa ce.
Cleaning the SprayArms
I f your dis hwasher cannot w ork beca use of the ice,
pl ease co ntact pr ofessiona l ser vice persons.
It is ne cess ar y t o cle an t h e s p ray a r ms regular l y f or har d
water chemicalswill clogthe sprayarmjetsa nd bearings.
To re move the spra y ar ms, screw off the nut c lock wise t o
ta ke out the wash er on t op of th e sp ra y a rm a nd r emo ve
the arm.
Wash the arm s in s oap y and war m w ater and u se a soft
brush toc lean the jets. Rep lace them aft er rinsing them
t horo ughly.
To Next Page
Loading...