EasyManua.ls Logo

Belling IDW604MK2 - Positioning the Appliance; Water Outlet

Belling IDW604MK2
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
In order t o avoid th at th er e is m ore w ater sta yi ng in the i nlet hose,
ple ase close the hyd rant after using.(For the models: no safety inlet hose.)
Positioning theAppliance
How to Drain Excess Water From Hoses
If the s ink is 1000 h igh er f rom the floor, the exces s wa ter i n h oses cann ot b e dr ai ned di rectly
into the sink. It will b en ecessary to d rain excess water from hoses into a b owl or suitable
conta iner that is he ld ou tside and lower than the sink.
The following things should be checked before starting the dishwasher.
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If y ou n eed a dr ain hose exte nsi on, m ake sure to use a simil ar dra in ho se.
It m ust be n o lo nger than 4 m etr es; o ther wise the cleanin g e ff ect o f t he dis hwa sh er coul db e re duc ed.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
3 There is a leakage at the connections of the conducts
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
Connect the c old water supply h ose to a t hread ed 3/4(inch) connector and make
sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time,
let the water runto make sure that the water is clear. This precaution is needed
to avoid the risk of the waterinlet to be blo cked and damage t he appliance.
The w ater su pply to the appliance can also be connected to the household hot water
line (such as, central system, heating system),as long as it does not exceeda
temperature of 60 .In this case, the wash cycle time will be shortened by about 15
minutes and the wash efficiency slightly reduced.
The connect ion must be made to the hot water line following the same procedures
as de scribed in the section for the connection to the cold water line.
Positi on the ap pliance in the desi red locatio n. The bac k sh ou ld r est ag ainst the wall behind i t, a nd the si des,
along t he adjacent c abin ets o r wa lls. The dis hwas her i s eq uipp ed w ith wate r suppl y and drai nhoses that can
be positioned either to the right o rthe left sides to facilitate pro per i nstallation.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid waterleaks.
En sure tha t the wat er dr ain h ose is not kinke d or squa she d.
Syphon Connection
The waste c onn ection m ust be at a h eight of betw een 40 c m ( minimum ) an d 10 0 c m (maxim um)
from thebottom of the dish.The water drain hose should befixed bya hoseclip.The free end of
the hos e mu st n ot be immers ed i n w ater.

Related product manuals