Witheachwashcycle.
Compartment
For programmes with pre-wash on ly.
(Follow the user instructions!)
Electric indic ator on control pane l (if provided).
Check the rinse aid level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the d ishwasher has run.
Check the regeneratio n
salt level
Load the baskets
Select a programme
Close the door, turn on the water tap. The machine will start working after about 10 seconds.
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent disp enser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
The y will also dry better.Unload the appliance, starting from the lower basket.
Changing the programm e
Add forgotten dishes in the
dishwasher .
Scrape off any large amount of leftover food. S often r emnants of burnt food in pa ns,
then l oad the baskets. Refer to the dishwasher loading instructions.
Press the Programme button until the selected programme lights up.
( See the section entitled Operationg instruction )āā
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF button.
If the appliance is switched
off during a wash cycle.
Open t he door c ar efully.
Hot st eam may esc ape
when the door isopened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the wash ing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the On/Off button to switch on the applianc e, Open the door.
1.Open the doo r a little to sto p the dishwasher.
2.After the spra y arms stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwa sher will start running again after 10 seconds.
For detailed operating method read the corresponding conte nt on t he instruction manual.
1. A running cycle can only be modified if it has been running for a short time. O therwise the detergent
m ay have already been rele ased a nd the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Open the door a little to s top the washing, then press the Program button for more than 3 seconds to
c ancel the running programme.
3. Select a new programme, then close the door. The machine will restart after about 10 seconds .
To Next Page
Loading...