Bellini BDW96W - Troubleshooting Common Problems; Error Codes and Technical Information

13
20
19
9. Troubleshooting Tips
ERROR CODES
When some malfunctions happen, the appliance will display error codes to warn you.
WARNING!
If overflow occurs, turn off the main water supply before calling a service. If there is water in the base
pan because of an overfill or small leak, the water should be removed before restarting the
dishwasher.
Codes
Meanings
Possible Causes
Water drainage malfunction
E1
E2
E3
E4
E5
E6
E7
Door open
Water inlet
Water drainage
Temperature sensor
Overflow/leakage
Water leakage
Heating element
The door is opened when the
dishwasher is operating
Water inlet malfunction
Temperature sensor malfunction
Overflow occurs/Water leakage occurs
Water leakage occurs
Abnormal heating
Attention
The followings should be checked before starting the dishwasher:
1 Whether the dishwasher is level and fixed
2 Whether the inlet valve is opened
3 Whether there is leakage at the connections of the conducts
4 Whether the wires are tightly connected
5 Whether the power is switched on
6 Whether the inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
After installation, please put this manual into the bags of printings.
The content of this manual is very helpful to the users.
Start of Dishwasher
Technical information
WDH
448mm 600mm 845mm
Voltage connected load:
Water pressure:
See rating label
0.04--1.0MPa
Power supply:
see rating label
Capacity:
9 Place settings
Hot water connection:
Max 60
GSM Sales Pty Ltd ABN: 53 007 582 475
For Warranty and technical queries: 1300 373 199 Aus Or 0508123108 NZ www.bellinia
ppliances.com.au
Model: BDW96W-F FINELINE: 5104010 Aus/NZ, BDW96X-F FINELINE: 5104011 Aus/NZ 45cm Freestanding Dishwasher