11
Using your Hob
To start cooking
• After powering on, the hob beeps once, all the indicators light up for 1 second then
go out, indicating that the hob has entered standby mode.
1. T
ouch the ON/OFF key, all the indicators show “– “
2. Place a suitable pan on the cooking zone that you
wish to use. Make sure the bottom of the pan and the
surface of the cooking zone are clean and dry.
3. Select the heating zone you wish to use. The indicator next to the key
will flash “5”. (This is the default power level when switching on)
4. Adjust the heat setting as required by touching the “-” or “+” keys.
• If you don’t choose a heat setting within 1
minute, the Ceramic hob will automatically
switch off. You will need to start again a
t
s
tep 1.
• You can modify the heat setting at any time
du
ring cooking by selecting the heating zone,
then touching the “-“ or “+’ keys.
When you have finished cooking
1. Select the heating zone that you wish to switch off.
2. T
urn the cooking zone off by scrolling down to”0”.
Make sure the display shows”0”.
3. T
urn the whole cooktop off by touching the
ON/OFF key.
Beware of hot surfaces
“H” will show which means cooking zone is too hot to touch. It will disappear when
the surface has cooled down to a safe temperature. It can also be used as an energy
saving function if you want to heat further pans, use the hotplate that is still hot.
To Next Page
Loading...