3
Quick Functions Overview
A. POWERING ON / OFF
• Opening the LCD screen cover will power the camcorder on automatically.
• Closing the LCD screen cover will power off the camcorder automatically.
• Once the LCD screen cover is open, you may press the [POWER] key for 3 seconds to power the camcorder on or off.
B. RECORDING VIDEO
• Once the camcorder is powered on, it will default to VIDEO mode. To begin recording video, press the [RECORD] button.
• Once recording begins, you may press the [OK] button to pause recording. Once paused, pressing the [OK] button again will resume recording.
• Pressing the [RECORD] button during a recording will stop the recording.
• To shoot a quick photo while recording a video, press [PHOTO] button. Please refer to page 7 for more detail.
C. SHOOTING PHOTOGRAPHS
• While in VIDEO mode, press the Press the [MODE] button to cycle to the PHOTO mode.
• Once in PHOTO mode, half-press the [PHOTO] button while the camcorder focuses on the intended subject.
• Once the camcorder's view is in focus, the on-screen focus frame will shift to green. Once the focus frame shifts to green, you may now fully press the
[PHOTO] button to shoot a photograph.
D. DATE & TIME SETUP
• Press the [ ] menu on the touchscreen display and select [ ] to enter the system settings menu.
• Press [BASIC SETTINGS] and then select [TIME SETTINGS].
• On the ttime settings screen, adjust the time and date by pressing the [LEFT] / [RIGHT] / [UP] / [DOWN] keys set until the desired date and time is set.
E. TIME / DATE STAMP
• Press the [ ] menu on the touchscreen display and select [ ] to enter the system settings menu.
• Press [DATE STAMP] and then select [ON] or [OFF]. Please note that selecting [ON] will print the date and time onto your recorded video and
photographs.
To Next Page
Loading...