Bellucci Slim Caffe - Troubleshooting; Common Problems and Solutions

Bellucci Slim Caffè Automatic Coffee Machine
Instruction Manual
Page 17 of 17
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The appliance does not
work.
The appliance is not
connected to the mains
supply.
- Plug in and press the on/off switch.
- Check the cable and the plug
No or delayed response in
several trials of pressing
on function key on the
panel
- Appliance is under an
electromagnetic
interference
- Dirt over the panel
- Unplug the appliance. Restart after few
minutes
- Clean the panel with the cloth provided
The coffee is not hot
enough.
- The cups have not been
preheated.
- The brewing unit is too
cold.
-Warm the cups
-Rinse the appliance at least 3 times before
making the coffee.
The coffee cannot come
out from spout.
Empty system function
maybe used before.
Press the hot water button until water can
come out from spout.
The first cup of coffee is
poor quality.
The first run of grinder
does not pour sufficient
quantity coffee power into
the brewing unit.
Throw the coffee away. The other coffees
will always be of good quality.
Coffee has no cream.
- Coffee bean is not fresh.
Change or use appropriate brand of coffee
bean.
The touch buttons are not
sensitive
Not pressing the touch
button from the front
direction of the appliance
Press the lower bottom part of the touch
button icon from the front direction of the
appliance.
The appliance takes too
long time to warm up.
Excessive scale has built
up.
Descale the appliance.
The water tank is removed
/ the water level is very
low in the water tank but
indicator have no alert.
The area near the water
tank connector is wet.
Wipe the water around the water tank
connector
Internal drip tray is filled
with a lot of water.
Coffee powder too fine
which block the water to
come out.
Adjust the coffee fineness to bigger dot
during grinder operation.
Coffee is delivered too
slowly or a drop at a time.
Coffee powder too fine
which block the water to
come out.
Adjust the coffee fineness to bigger dot
during grinder operation.
Lack of bean indicator
flashes but there is still a
lot of coffee bean inside
the container.
Internal coffee powder
outlet is blocked.
To follow the steps of section E (V. Cleaning
coffee powder outlet).