Need help?Do you have a question about the Belmont RAPID INFUSER RI-2 and is the answer not in the manual?
Initial setup instructions including system inspection and power connection.
Steps for securely mounting the unit and reservoir support onto an IV pole.
Detailed steps for connecting power, turning on, and priming the internal circuit and patient line.
Procedure for connecting to the patient and initiating the infusion process.
Instructions on how to change the preset bolus volume from 100 to 1000 mL.
How to adjust the bolus infusion rate based on previous flow settings.
Procedure for replacing the standard reservoir chamber and filter.
Detailed steps for setting up and connecting the 3.0 Liter Reservoir.
Troubleshooting causes and solutions for power and air detection alarms.
Causes and solutions for fluid out and high-pressure operational alarms.
Troubleshooting for low battery and missing disposable set alarms.
Causes and solutions for heating-related system errors and alarms.
List of internal system faults and their corresponding solutions.
Solutions for difficulties related to battery power and dim display.
Troubleshooting slow flow rates and unresponsive keypad issues.
Solutions for the unit failing to prime or being unable to calibrate.
Guide to adjusting date/time, display brightness, key rate, bolus volume, and pressure limit.
Identifies solutions that are incompatible with the Rapid Infuser.
Provides conversion and heating data for various solutions.
General| Brand | Belmont |
|---|---|
| Model | RAPID INFUSER RI-2 |
| Category | Dental equipment |
| Language | English |
To Next Page