2 3
FCC ID: X26PH13, Type Designation: PH13, FCC ID: X26PH312, Type Designation: PH312, FCC ID:
X26BO312, Type Designation: BO312, FCC ID: X26BO13, Type Designation: BO13
Please see page 4 for a listing of models referring to the above types.
This device operates in the frequency range of 2.4 GHz - 2.48 GHz. This device includes
an RF transmitter that operates in the range of 2.4 GHz - 2.48 GHz.
Statement:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harm-
ful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from the one in which the receiver is con-
nected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications can void the user´s authority to operate the equipment
List of countries:
Products without wireless functionality are intended for worldwide sales.
Products with wireless functionality are intended for sale in countries within European Economic Area as
well as Switzerland.
Specification of restrictions:
You are not allowed to operate the equipment within 20 km of the centre of Ny Ålesund, Norway.
The products are in compliance with the following regulatory requirements:
• In EU: the device conforms to the Essential Requirements according to Annex I of Council Directive
93/42/EEC for medical devices (MDD) and essential requirements and other relevant provisions of Direc-
tive 1999/5/EC (R&TTE). The declaration of conformity may be consulted at www.beltone-hearing.com
• In US: FCC CFR 47 Part 15, subpart C, section 15.249
To Next Page