15
ASSEMBLY
Wire Spool Installation / Wire Setup
1. Turn the power Switch OFF and unplug the Welder before proceeding.
2. Pull up on the Door Latch, then open the Door.
3. 1-2 pound Wire Spool installation: Remove the Wingnut, spring and washers.
If replacing a Spool, remove the old Spool and all remaining wire from the liners.
4. Place the new Wire Spool over the Spool Spindle and against the Spool Brake
Pad as illustrated. to prevent wire feed problems, set the Spool so that it will
unwind clockwise.
5. Replace the Spacer over the Spool Spindle and secure Spool in place with the
Wingnut.
To Next Page
Loading...