19
SETTING THE FENCE SQUARE WITH THE TABLE
1. Make sure that the battery is removed from the saw.
2. Push the saw arm (3) down to its lowest position and engage the release
knob (4) to hold the saw arm in the transport position.
3. Loosen the mitre locks (20) and lift the latch (21).
4. Rotate the table (16) until the pointer is positioned at 0°.
5. Release mitre latch (21) and tighten the mitre locks.
6. Using a 5 mm hex key, loosen the two screws securing the fence
(14) to the base.
7. Place a square against the fence (14) and alongside the blade.
8. Adjust the fence (14) until it is square with the blade.
9. Tighten the screws securing the fence (14).
10. Loosen the Phillips head screw holding the pointer of the mitre scale (17) and
adjust it so that it accurately indicates the zero position on the mitre scale.
11. Retighten the screw securing the mitre scale pointer.
CHANGING A BLADE
1. Make sure that the battery is removed from the power point.
2. Push down on the operating handle (5) and pull the release knob (4) to
disengage the saw arm (3).
3. Raise the saw arm (3) to its highest position.
4. Loosen the cover plate screw about 2 turns with a Phillips screwdriver.
Do not remove this screw from the tool.
5. Pull the rotating blade guard (8) down. When the rotating blade guard (8)
is positioned over the upper fixed blade guard (6) it is possible to access
the blade bolt.
6. Lift and hold up the lower blade guard (8) to expose the threaded blade bolt.
7. Hold the rotating guard (8) up and press the spindle lock button (22).
Rotate the blade until the spindle locks.
8. Use the 6 mm hex key provided to loosen and remove the blade bolt.
(Loosen in a clockwise direction as the blade screw has a left-hand thread).
9. Remove the flat washer, outer blade washer and the blade.
10. Wipe a drop of oil onto the inner blade washer and the outer blade washer where
they contact the blade.
11. Fit the new blade onto the spindle taking care that the inner blade washer sits
behind the blade.
12. Replace the outer blade washer.
13. Depress the spindle lock button and replace the flat washer and blade bolt.
14. Use the 6 mm hex key to tighten the blade bolt securely (tighten in an anti-
clockwise direction).
To Next Page
Loading...
