13
This machine is equipped with live hose reel. To unwind the hose, turn hose reel
handle counterclockwise. To wind the hose, turn hose reel handle clockwise. There
is a hose clip on the end of hose which is used to clamp onto the winded hose for
storage.
NOTE: Pull the hose reel handle out and uncoil hose from the hose reel before use.
7. When you are finished turn the switch to “OFF/O” position.
8. Unplug the power cord from the power outlet.
9. Turn o water supply.
10. After motor and water supply are turned o, trigger gun to depressurize system.
MAINTENANCE
WATER FILTER AND NOZZLE CLEANING INSTRUCTIONS
A clogged or partially clogged water filter or nozzle can cause significant reduction
of water pressure coming out of the nozzle and/or cause the unit to pulsate while
spraying.
1. The water filter was installed inside the water inlet quick connector, should be
cleaned periodically. Rinse it with clean tap water, and then place it back into the
water inlet quick connector.
2. Using the nozzle tip cleaner provided (or an unfolded paper clip), insert the wire
into the nozzle hole and move back and forth until debris is dislodged. Back flush
water through the nozzles using garden hose and highest pressure available (either
standard water nozzle or use your thumb over the nozzle to create water pressure
for back flush).
STORAGE
Do not store pressure washer outdoors and store the pressure cleaner, parts, and-
accessories in an area with a temperature above 32°F (0°C).
Do not store pressure washer where it might freeze while there's water inside the
machine.
Serious damage will occur to the water system, pump and / or motor.
To Next Page
Loading...
