15
The power washer turns
on for 2 seconds, shuts
o,and will not turn
back on. Do I have a
defective unit?
It sounds like your power washer is working just fine. When the water is
connected, the accessories are assembled properly, and the power switch
is turned on, the power washer may turn on for 1-2 seconds to prime the
pump. It automatically shuts o and waits for the spray gun trigger to be
pressed. When the trigger is pressed, water starts flowing through the
pump. The water sensor in the pump “senses” the moving water and
automatically turns the power washer on. Or, turn the power switch to o,
hold in the trigger on the spray gun, so that you have a steady stream of
water. While you are holding the trigger open on the spray gun, at the same
time, turn the power switch on.
EXPLODED VIEW
To Next Page
Loading...
