FITTING THE SEAT AND OPERATOR PRESENCE SWITCH
1. Unfasten the two M8 nuts and bolts
(A) from the Seat Brackets located on
top of the mower. (Use the 13-15 open-
end wrench from the accessories tools
kit)
2. Mount the Seat onto the Seat Brackets
using the released two M8 nuts and
bolts (A) as illustrated.
3. Connect the Wire Harness (B) to the
Operator Presence Switch (C) located
under the seat as illustrated.
Be sure that the connection is
complete.
The total weight (trailer and load, including the operator) must not
exceed 136 kg (300 lbs.). See complete notes under REGULATIONS FOR TOWING.
CONNECTING THE BATTERY
Sulfuric acid is poisonous.
The electrolytic fluid is a solution of sulfuric acid.
Sulfuric acid is corrosive.
Sulfuric acid can cause blindness or severe burns.
To Next Page
Loading...
