25
Never throw the battery away into the environment.
Follow local authorities’ deposals methods when changing batteries.
1. Fit the battery in its housing.
Position the battery with the polarities and as indicated.
2. Connect the battery connectors to the machine connection leads and tighten the
two screws. then cover the protective cap for the two wires in place. (Use the
open-end wrench 8-10 and cross screwdriver in accessories tools)
3. Secure the battery with the small rubber strap.
THIS MACHINE USES 12V / 18Ah
BATTERY.
The battery is fully charged before
leaving the factory. If the battery is
found to be insufficient, please use a 12V
1A charger to charge the battery.
MOUNTING THE FRONT BUMPER
1. Mount the bumper bracket L and
bumper bracket R on the bumper,
using four M8 nuts and four M8 x 20
screws. (Use the open-end wrench
13-15 in accessories tools.)
2. Mount the front bumper on the
bottom of the frame using the four M8
nuts and four M8 x 20 screws. (Use
the open-end wrench 13-15 in
accessories tools.)
To Next Page
Loading...
