50
REPLACING AND REPAIRING THE TIRES
The tires are “Tubeless” and so all
punctures must be repaired by a tire
repairer following the procedures
required for this kind of tire.
REPLACING A FUSE
The machine is fitted with 20A fuses.
When it blows, the machine stops, the
dashboard light switches off, the
battery gradually runs out, and the
machine will have problems starting.
Remove the fuse and replace it with
the same type of fuse.
A blown fuse must always be replaced with an identical fuse rated
with the same ampere. Never replace the fuse with another that is rated differently.
DISMANTLING, REPLACING AND REMOUNTING THE BLADES
Always wear work gloves when handling the blades. Before you inspect
or remove the blade, stop the engine, and disconnect the wire to the spark plug.
Damaged or bent blades must always be replaced; never try to repair
them!
ALWAYS USE ORIGINAL BLADES BEARING THE SYMBOL “ZHONG JIAN” !
▪ Make sure the blades are correctly balanced.
▪ Make sure you put them back in the right place by referring to the code and
rotate direction stamped on the outside of each blade.
▪ Blade models please refer to the chapter “SPECIFICATIONS”.
To Next Page
Loading...
