Benchmark HPA4 - Remote Control

Instruction Manual for HPA4 with 1.0.X Firmware – REV B Page 11
Remote Control
The remote control is designed to control the
HPA4 and any Benchmark D/A converter that
supports remote control.
The bottom six input selection buttons select
the DAC inputs if the DAC MODE is enabled
(on the REMOTE setup screen).
The HPA4 inputs are controlled with the
INPUT ARROWS.
The chart at the right summarizes the
functions of the IR remote control.
ON
Turns the HPA4 on. Any devices
slaved to the 12V TRIGGER will
also turn on in a controlled
sequence.
If the HPA4 is ON, this button
toggles the OUTPUT GROUP
SELECTION (headphone, line, or
both).
OFF
Turns the unit off. Any devices
slaved to the 12V TRIGGER will
turn off in a controlled sequence.
VOLUME
ARROWS
Turns the volume up or down.
Volume up cancels MUTE and
DIM.
Volume will only be adjusted on
selected output group(s).
-20 dB
DIM
Toggles the -20 dB DIM function.
DIM will only be toggled on
selected output group(s).
MUTE
Toggles the MUTE function.
MUTE will only be toggled on
selected output group(s).
INPUT
ARROWS
Scrolls through the enabled
inputs on the HPA4.
D1
Selects input D1 on DAC if
connected.
D2
Selects input D2 on DAC if
connected.
D3
Selects input D3 on DAC if
connected.
D4
Selects input D4 on DAC if
connected.
USB
Selects USB input on DAC if
connected.
Analog
Selects analog input(s) on DAC if
connected.