18 Bend-Tech Dragon A150
Plasma Cutting Guide
Consumables
01
Cut Charts
Cutting Speed
High-speed dross Cutting speed too fast - arc
is lagging behind. Usually
to remove.
Low-speed dross Cutting speed too low - arc
jumping ahead. Large droplets
that are easier to remove than
high-speed but not ideal
Top spatter Cutting speed too fast
Select the appropriate settings for:
• Material type
• Material Thickness
• Desired cut quality
• Productivity goals
• Type of gas being used
• Gas pressure
• Torch distance or arc voltage
• Cutting speed
• Consumables being used
To Next Page
Loading...
