19Bend-Tech Dragon A150
Plasma Cutting Guide
Cutting Charts
02
02
Cutting Charts
Before Using these Charts
The cutting charts in this guide have been compiled based on Hypertherm recommended
settings as well as Bend-Tech experience in using and testing the Dragon A150. Bend-Tech
is providing these charts as a baseline. These settings may need to be adjusted based on
The Dragon A150 is programmed with preset cut values. These values are a baseline that
will get the Operator up and running. Cut settings can be adjusted in the Tube Library in the
Machine, Lead In/Out and NRC interfaces.
To Next Page
Loading...
