p.16
Step 4: Push the air line into the bottom of
the air pressure regulator to connect it.
Tip: Adjusting the bolts connected to the gate's swinging
arm to allow for clearance may be a necessary step.
Electronic Connections
Step 1: Use your fingers or the
ratchet and 3/8 inch socket to
remove the 3/8 inch nuts
securing the bottom electronics
guard plate underneath the back
side of the gate. Remove the guard plate itself to
reveal the electronics core.
Note: If you are using 230v instead of the standard
115v, you will have to change the voltage settings.
Please see the Voltage Settings page at the end of this
manual for further details on how to change this.
To Next Page
Loading...
