p.17
Step 2: Connect the parallel
cord to both the back of the
machine's electrical core and the
operator panel box. Make sure
to secure them both by
tightening the set screws on each end of the cord.
Step 3: Connect the 5v power source to the back
of the operator panel box and connect the other
side to a wall outlet.
Step 4: Connect an Ethernet cable from
your operator panel box to your
computer.
Step 5: Return the electronics
guard plate and use the ratchet
with the 3/8 inch socket to
secure the four 3/8 inch nuts.
Step 6: Connect the machine
power cord to the machine
underneath the electronics guard
plate and connect the other side
to a wall outlet.
To Next Page
Loading...
