p.18
Step 7: Attach the alligator clamp from
your torch power source to the ground
wire underneath the machine's electronics
core.
Step 8: Attach the torch trigger
connection from the machine's
electronics core (with the red and black
wires) to the back of your torch power
source.
Step 9: Attach your air hose to both the
back of the torch power source and to the
back of the machine located on the
electronics guard plate.
Step 10: Flip the switch on the back of
the operator panel box. The red light will
turn on to indicate that it is running.
Make sure to flip this switch first.
Step 11: Flip the switch on the
electronics core panel. The machine
motors will turn on and begin humming
to indicate that the machine is running.
To Next Page
Loading...
