p.19
Modifying and Installing your
Hypertherm Torch
For Hypertherm: 45 Amp If your Hypertherm 45 torch is
brand new or unaltered, there are a few adjustments that must
be made to the torch itself in order to install it onto the
Dragon machine's tool head.
Step 1: Remove the brass teeth from the
torch itself by using a phillips head
screwdriver. There are 2 screws that
must be removed in this step.
Step 2: Set aside the remote on/off
pendant as we will be using the Dragon
software to control the machine.
Step 3: Install the torch head into
the adjustable mounting brackets
on the face of the tool head plate.
Note: The height of the torch
tip should lie within the stroke of the
engraver tip next to it. This is to ensure that the torch
will not crash into large diameter tubing while the
engraver is in use. The mounting brackets will then be
tightened with a 3/16 inch hex wrench.
To Next Page
Loading...
