p.20
For Hypertherm: 65 Amp Installing and modifying your 65
amp torch is slightly different than with the 45 amp. Follow
the steps below in order to install the 65 amp torch onto your
Dragon machine.
Step 1: Remove the red rubber cap at the head (if attached)
and use a phillips head screwdriver to remove the 3
screws accessible from the head of the torch.
Step 2: Now, loosen the connection at the
rear of the torch by unscrewing the clasp
attached to the air hose. (As seen in
picture.)
Step 3: Then, loosen the section of the
ceramic torch nearest the head, remove it
and set it aside. Note: The bulk of the
torch will turn; not the section nearest
the head.
Step 4: Finally, loosen the next ceramic
section all the way and maneuver it to
one side in order to slide the brass teeth
out from its slot on the torch.
To Next Page
Loading...
