Need help?Do you have a question about the Bendix/King KY 196 and is the answer not in the manual?
Provides overview of physical, mechanical, and electrical characteristics.
Details the TSO'd 720 channel communications transceiver and its connections.
Lists specifications like TSO compliance, dimensions, power requirements, and frequency range.
Lists the components and parts included with the transceiver unit.
Lists external components needed for operation but not included.
Outlines the FCC license needed for transmitter operation.
Suggests factors and suggestions for satisfactory equipment performance.
Instructions for careful unpacking and visual inspection for damage.
General guidance on installing the unit, wiring, and interconnect diagrams.
Recommendations for installing a conventional 50 ohm vertically polarized COMM antenna.
Details on assembling contact terminals and inserting them into the connector housing.
Steps for sliding the unit into the mounting rack and securing it.
Recommends an operation performance flight test and checks.
Instructions for turning on the unit, setting audio levels, and squelch.
Steps to power on the unit and initial memory storage behavior.
Explains the "T" indicator that appears during COMM transmission.
How to select frequencies and transfer them between USE and STANDBY windows.
Used to program frequencies into memory and select operating modes.
Recalls previously stored channel information for use.
Allows direct selection of frequencies in the USE window by turning off/on.
Installs a remote switch to transfer frequencies between STANDBY and USE windows.
Uses a remote switch to increment through memory channels in Channel Mode.
General| Modulation | AM |
|---|---|
| Channel Spacing | 25 kHz |
| Operating Voltage | 13.75 VDC |
| Power Supply | 13.75 VDC |
| Type | VHF Transceiver |
| Frequency Range | 118.000 - 136.975 MHz |
| Channels | 760 |
To Next Page
