BENDIX GEN 4 GEN 5 ABS - Blink Codes Description

21
Fault Codes
11 –/– No Trouble Found
21 001/000 Sensor air gap too large. Left Steer Sensor
22 001/008 Air gap too large or sensor shorted.
23 001/010 Speed Sensor signal is noisy.
24 001/008 Wheel locked too long during an ABS cycle.
25 001/008 High deceleration rate at wheel site or sensor shorted.
26 001/012 Sensor shorted low or high or sensor open.
27 001/012 Internal error at the sensor port of the ECU.
28 001/002 Sensor in the wrong location for the system configuration.
31 002/000 Sensor air gap too large. Right Steer Sensor
32 002/008 Air gap too large or sensor shorted.
33 002/010 Speed Sensor signal is noisy.
34 002/008 Wheel locked too long during an ABS cycle.
35 002/008 High deceleration rate at wheel site or sensor shorted.
36 002/012 Sensor shorted low or high or sensor open.
37 002/012 Internal error at the sensor port of the ECU.
38 002/002 Sensor in the wrong location for the system configuration.
41 003/000 Sensor air gap too large. Left Rear Sensor.
42 003/008 Air gap too large or sensor shorted.
43 003/010 Speed Sensor signal is noisy.
44 003/008 Wheel locked too long during an ABS cycle.
45 003/008 High deceleration rate at wheel site or sensor shorted.
46 003/012 Sensor shorted low or high or sensor open.
47 003/012 Internal error at the sensor port of the ECU.
48 003/002 Sensor in the wrong location for the system configuration.
51 004/000 Sensor air gap too large. Right Rear Sensor.
52 004/008 Air gap too large or sensor shorted.
53 004/010 Speed Sensor signal is noisy.
54 004/008 Wheel locked for too long during an ABS cycle.
55 004/008 High deceleration rate at a wheel site or sensor shorted.
56 004/012 Sensor shorted low or high or sensor open.
57 004/012 Internal error at the sensor port of the ECU.
58 004/002 Sensor in the wrong location for the system configuration.
Blink Codes
1st. 2nd.
Description
Location
MID 136
SID/FMI