23
Fault Codes
10 1 009/003 Short circuit from the release solenoid to voltage. Left Rear Axle PMV.
10 2 009/004 Short circuit from the release solenoid to ground.
10 3 009/005 Open circuit at the release solenoid.
10 4 009/005 Open circuit on the common line to the valve.
10 5 009/003 Short circuit from the hold solenoid to voltage.
10 6 009/004 Short circuit from the hold solenoid to ground.
10 7 009/005 Open circuit at the hold solenoid. Left Rear Axle PMV (cont.).
10 8 009/002 System configuration is incorrect.
10 or 11 9 014/003 Common side of valves – stray voltage detected. PMV Commons.
10 or 11 10 014/003 Common side of valves shorted high.
10 or 11 11 014/004 Common side of the valves shorted to ground.
11 1 010/003 Short circuit from the release solenoid to voltage. Right Rear Axle PMV.
11 2 010/004 Short circuit from the release solenoid to ground.
11 3 010/005 Open circuit at the release solenoid.
11 4 010/005 Open circuit on the common line to the valve.
11 5 010/003 Short circuit from the hold solenoid to voltage.
11 6 010/004 Short circuit from the hold solenoid to ground.
11 7 010/005 Open circuit at the hold solenoid.
11 8 010/002 System configuration is incorrect.
12 1 011/003 Short circuit from the release solenoid to voltage Left Rear Axle PMV.
12 2 011/004 Short circuit from the release solenoid to ground.
12 3 011/005 Open circuit at the release solenoid.
12 4 011/005 Open circuit on the common line to the valve.
12 5 011/003 Short circuit from the hold solenoid to voltage.
12 6 011/004 Short circuit from the hold solenoid to ground.
12 7 011/005 Open circuit at the hold solenoid.
12 8 011/002 System configuration is incorrect.
13 1 012/003 Short circuit from the release solenoid to voltage. Right Rear Axle PMV.
13 2 012/004 Short circuit from the release solenoid to ground.
13 3 012/005 Open circuit at the release solenoid.
13 4 012/005 Open circuit on the common line to the valve.
13 5 012/003 Short circuit from the hold solenoid to voltage.
13 6 012/004 Short circuit from the hold solenoid to ground.
13 7 012/005 Open circuit at the hold solenoid.
13 8 012/002 System configuration is incorrect.
Blink Codes
1st. 2nd.
Description
Location
MID 136
SID/FMI