BENDIX SmarTire Operator's Manual

BW8002 Page 17
USING THE SMARTIRE TPMS SYSTEM
NOTE: It is normal for the TPMS system to
take up to 5 minutes for all tire sensor data to
be received and displayed to the driver as the
sensors transmit data every 3-5 minutes. In
some instances the tire could be in a position
where the sensor signal could be blocked and
not seen by the receiver. In this case, after 35
minutes of not seeing a sensor, the system
will issue a Sensor Fault Alert for that
location. If a Sensor Fault Alert occurs and does not clear after the
vehicle is driven, please report this condition to your maintenance
personnel as it may indicate a problem with the system.
GETTING STARTED
When the vehicle’s ignition switch is turned on, the SmarTire™ system will
power up and the display will indicate that the system is initializing. After a
short period, the display will show the “TPMS Ready” screen indicating that
the system is ready to receive tire data from the sensors.
If an Alert icon (triangle with an exclamation
mark) is displayed and the LED light is
illuminated when the TPMS Ready screen is
shown, this is an indication that an active
alert has been detected and should be
investigated / corrected before the vehicle is
driven. Bendix recommends that tire pressure and temperature conditions
always be corrected before a vehicle is driven to ensure the safety of the
driver, vehicle and cargo.

BENDIX SmarTire Specifications

General

Brand	BENDIX
Model	SmarTire
Category	Measuring Instruments
Language	English