BW8002 Page 19
ALERTS & WARNINGS
REACTING TO ALERTS & WARNINGS
IMPORTANT: It is important to always react to the
alerts and warnings provided by the SmarTire TPMS
(Tire Pressure Monitoring System). It is
recommended that tire conditions always be
corrected as soon as possible and before the
vehicle is driven. Once the pressure is restored or
the temperature is reduced, the alert will
automatically turn off.
PRESSURE AND TEMPERATURE ALERTS
FIRST ALERT LEVEL (FAL): PRESSURE DEVIATION ALERT
Indicated By: Flashing LED Light, Alert Triangle, + or - Deviation Value.
This alert is intended to give you an early
indication that the tire is low/high. This alert is
typically based on the temperature
compensated value (if temperature
compensation is selected for the alert). If so,
you may see that the pressure is above the
CIP, but due to the temperature of the tire, the
pressure is actually low or high depending on
the deviation value showed.
The axle designator and the highlighted wheel
position indicate the position of the tire that is
under- or over-inflated. The pressure deviation value indicates the amount of
under (-), or over (+) inflation that should be corrected.
To acknowledge this alert and return to the TPMS ready screen, press any
button. The LED will stop flashing but remain illuminated until the problem is
corrected. To correct the problem, add or remove air to the affected tire as
indicated by the deviation value. When the deviation value is 0 the tire is
properly inflated.
To Next Page
Loading...
Need help?
General
