BW8002 Page 20
SECOND ALERT LEVEL (SAL): CRITICAL LOW PRESSURE ALERT
Indicated By: Flashing LED Light, Alert Tire Icon, Deviation Value.
This alert is intended to give you an indication
that the tire is critically low and needs
immediate attention to prevent a critical
failure.
The axle designator and the highlighted wheel
position indicates the tire that is under inflated.
The pressure deviation value indicates the
amount of under- or over-inflation.
IMPORTANT: This alert indicates that the tire is critically underinflated
and should be addressed immediately.
To acknowledge this alert and return to the TPMS ready screen, press any
button. The LED will stop flashing but remain illuminated until the problem is
corrected. To correct the problem add air to the affected tire as indicated by
the deviation value. When the deviation value is 0 the tire is properly inflated.
HIGH TEMPERATURE ALERT
Indicated by: Flashing LED Light, Alert Thermometer, Temperature
Value.
This alert is intended to give you an indication
that the temperature of the air in the tire has
reached a critical point and should be
investigated.
The axle designator and the highlighted wheel
position indicates the tire that is critically hot.
High tire temperatures are typically caused by
under-inflation and the system will usually
provide a pressure alert in advance of a
temperature alert. If triggered on its own, this
alert can be an indication of an alternative
problem, such as a dragging brake or a bearing failure.
To acknowledge this alert and return to the TPMS ready screen, press any
button. The LED will stop flashing but remain illuminated until the problem is
corrected. To correct the problem investigate what is causing the elevated
temperature.
To Next Page
Loading...
Need help?
General
